Saniflow Manual Operated Hand Dryer, Epoxy Steel White Finish
Manufacturer Information:
Name or company: Pending update
Email: Pending update
Postal address: Pending update
City: Pending update
Country: Pending update
Responsible person information:
Name or company: Pending update
Email: Pending update
Postal address: Pending update
City: Pending update
Country: Pending update
Warnings and product safety information:
- Warm air hand dryer.
- Push-button operated.
- Maximum power and airflow.
- Maximum robustness and vandal-proof.
- Suitable for very high traffic facilities.
- It normally goes along with a soap dispenser.
- Steel one-piece cover white epoxy coated, 1,5 mm thick. Cover fixed to the base by means of 2 vandal-proof lock screws and lock with special Saniflow ® wrench.
- Base in aluminium, 3 mm thick, with 4 Ø 8 mm holes for wall mounting.
- Fire resistant plastic UL 94-VO fan scroll.
- Universal brush motor, 5500 rpm, F class, incorporates a safety thermostat and a self-resetable thermal cut-off at 120 ºC.
- Aluminium centrifugal double symmetrical inlet fan wheel.
- Waved wire NiCr heating element on a mica frame that incorporates a self-resetable safety thermal cut-off at 80 ºC.
- Nozzle in chrome plated zamak, 22 μ thick.
- Push-button in chrome plated zamak, 22 μ thick, that activates an electronic timer with a 35 second cycle.
| Voltage | 220-240 V |
| Frequency | 50 / 60 Hz |
| Electrical insulation | Class I |
| Dimensions | 245x 276x 210 mm |
| Weight | 4.9 Kg |
| Effective airflow | 330 m3 / h / 5500 l / min |
| Nominal flow rate | 470 m3 / h / 7800 l / min |
| Air speed | 96 Km / h |
| Total power | 2250 W |
| Engine | 250 W |
| Power Resistance | 2000 W |
| Consumption | 10 A |
| r.p.m. | 5500 |
| T. air (D = 10 cm / T amb = 21 º C) | 53 º C |
| Noise level (2 m) | 70 dB |
| Index protection | IP23 |
Between sink and door. It is recommended not to install between sink, or beside
urinals, toilets and showers. On automatic models, when installed on a marble ledge, the minimum distance from the dryer to the ledge must be 400mm. It is recommended that hand dryers be distributed throughout the basin area to avoid overcrowding.