Automatický vysoušeč rukou SANIFLOW, nerezová ocel Aisi 304, lesklá
Informace o výrobci:
Název nebo společnost: Čeká na aktualizaci
E-mail: Čeká na aktualizaci
Poštovní adresa: Čeká na aktualizaci
Město: Čeká na aktualizaci
Země: Čeká na aktualizaci
Informace o odpovědné osobě:
Název nebo společnost: Čeká na aktualizaci
E-mail: Čeká na aktualizaci
Poštovní adresa: Čeká na aktualizaci
Město: Čeká na aktualizaci
Země: Čeká na aktualizaci
Varování a informace o bezpečnosti výrobku:
Výrobek je v souladu s obecným nařízením o bezpečnosti výrobků.
- Hand dryer, warm air.
- Automatic activation for approximation of the hands.
- Maximum robustness and power.
- Maximum anti-vandalism.
- Suitable for toilets of high pass frequency.
- Usually accompanied by a soap dispenser.
- Housing, one-piece stainless steel AISI 304, bright finish, 1.5 mm thick. Subject to the base by 2 screws anti-vandal security and lock with special key provided Saniflow ®.
- Base, Aluminum 3 mm thick, with 4 Ø 8 mm holes for wall mounting.
- Scroll plastic UL 94-V0 flame retardant.
- Motor, Universal, 5500 rpm, Class F, includes thermal limiting, with sealed ball bearings and self lubricating.
- Centrifugal, double-entry symmetric aluminum.
- Resistance, undulating wire of NiCr, incorporates a thermal limiter.
- Nozzle, chrome zamak, thickness 22 μm.
- Electronic detection sensor, infra-red beam, adjustable sensing distance.
| Voltage | 220-240 V |
| Frequency | 50 / 60 Hz |
| Electrical insulation | Class I |
| Dimensions | 245x 276x 210 mm |
| Weight | 4.65 kg |
| Effective airflow | 330 m3 / h / 5500 l / min |
| Nominal flow rate | 470 m3 / h / 7800 l / min |
| Air speed | 96 Km / h |
| Total power | 2250 W |
| Engine | 250 W |
| Power Resistance | 2000 W |
| Consumption | 10 A |
| r.p.m. | 5500 |
| T. air (D = 10 cm / T amb = 21 º C) | 53 º C |
| Noise level (2 m) | 70 dB |
| Index protection | IP23 |
Between sink and door. It is recommended not to install between sink, or next to urinals, toilets and showers. On automatic models, when installed on a marble ledge, the minimum distance from the dryer to the ledge must be 400mm. It is recommended that hand dryers be distributed throughout the basin area to avoid overcrowding.